The original and preferred Choice, From the assembly line to windshield replacement


betaseal adhesives

BETASEAL glass bonding adhesives are recognized as the technology leader in glass bonding by both Original Equipment Manufacturers (OEM) and the Aftermarket.

BETASEAL glass bonding adhesives have a long history of innovation. Over 85% of North American OEMs use BETASEAL™ adhesives, more than 60% globally.

That’s more than one billion installations worldwide.

BETASEAL™ aftermarket products are validated in the same lab (TS 16949 certified) as OEM products that are used to assemble vehicles

  • Aftermarket Replacement Glass (ARG) products are tested to the harshest conditions from OEM standards.

auto crash.jpg



BETASEAL™ Urethane Adhesives

Get the strength you need for structural safety 

Q: What holds your windshield in place?

A: Automakers use urethane adhesive to bond the windshield to the body of your car.

Q: What does the windshield do for safety?

A: The windshield adds structural strength to the overall vehicle and, for some air bags to work as designed, they must deflect off the windshield. The adhesive must hold the windshield in place during impact. To keep the occupants of your vehicle safe, it’s important to use a quality windshield adhesive that is approved by the vehicle manufacturer and proper installation procedures.

Q: How do you know your original windshield installation was safe?

A: There are government and manufacturer requirements imposed for motor vehicle safety. Vehicle manufacturers must certify each make and model passes a series of tests, including Federal Motor Vehicle Safety Standard windshield retention crash (FMVSS 212), occupant retention (FMVSS 208), roof crush (FMVSS 216) and intrusion (FMVSS 219) tests. Manufacturers also have their own standards, which may exceed government requirements. Both the adhesive and the installationprocess must pass these destructive tests.

When your windshield is replaced, be sure it is bonded with a high-quality adhesive approved for the original installation, and is installed according to all industry standards. Nearly all vehicles manufactured in the United States had their windshields installed at the factory with BETASEAL adhesives.

Q: Will your replacement windshield give the same protection as the original?

A: Most auto glass installers are concerned about passenger safety. They BETASEAL™ adhesives to replace your glass with bond strength equal to that of the manufacturer’s original installation.

Q: How do you know BETASEAL™ adhesives will retain your windshield during a crash?

A: BETASEAL™ adhesives are crash proven. We test our adhesives by replacing a windshield in a car and crashing it head on into a solid wall. The risk is too high to rely solely on theories and laboratory tests.

BETASEAL™ adhesives’ minimum drive-away times are confirmed through actual vehicle crashes.

Q: Will the adhesive bond last?

A: All BETSEAL™ adhesives are subjected to severe long-term durability laboratory and field tests to ensure lasting performance. Adhesives are exposed to cold, heat, humidity, rain and salt air for years to verify long-term strength.

Q: Why is it important to wait the prescribed time before driving the car?

A: For safety. It takes time to meet FMVSS requirements for windshield retention. The longer the urethane cures, the stronger the bond.

BETASEAL™ urethane adhesives used to originally install windshields in nearly all domestic vehicles and two-thirds of all vehicles manufactured worldwide.




BETASEAL has the industry’s most complete portfolio of products. This enables your technician to provide you with the most cost-effective windshield replacement possible.


Need your car in a hurry?

Ask your technician about 30-minute Minimum Drive Away!


30-minute Minimum Drive Away!

Get your car back fast from your auto glass professional when BETASEAL™ Xpress30 Advanced Cure Auto Glass Urethane Adhesives is used.

You can drive your car just 30 minutes after installation at temperatures as low as 0°F.